Industry News

Do You Know About LEDs Lifetime?  

Views : 1128
Update time : 2018-09-03 21:16:00
Do You Know About LEDs Lifetime? 

Solid-state devices such as LEDs are subject to very limited wear and tear if operated at low currents and at low temperatures. Many of the LEDs made in the 1970s and 1980s are still in service today. Typical lifetimes quoted are 25,000 to 100,000 hours, but heat and current settings can extend or shorten this time significantly.

The most common symptom of LED (and diode laser) failure is the gradual lowering of light output and loss of efficiency. Sudden failures, although rare, can occur as well. Early red LEDs were notable for their short service life. With the development of high-power LEDs the devices are subjected to higher junction temperatures and higher current densities than traditional devices. LED performance is temperature dependent. Most manufacturers' published ratings of LEDs are for an operating temperature of 25 °C. LEDs used outdoors, such as traffic signals or in-pavement signal lights, indoor and outdoor lighting and that are utilized in climates where the temperature within the light fixture gets very hot, could result in low signal intensities or even failure. LED light output rises at lower temperatures, leveling off, depending on type, at around ?30 °C. Thus, LED technology may be a good replacement in uses such as supermarket freezer lighting and will last longer than other technologies.

Because LEDs emit less heat than incandescent bulbs, they are an energy-efficient technology for uses such as in freezers and refrigerators. . Similarly, this lack of waste heat generation has been observed to sometimes cause significant problems with street traffic signals and airport runway lighting in snow-prone areas. In response to this problem, some LED lighting systems have been designed with an added heating circuit at the expense of reduced overall electrical efficiency of the system; additionally, research has been done to develop heat sink technologies that will transfer heat produced within the junction to appropriate areas of the light fixture.[Source: List of LED failure modes]

WWW.CADLED.COM which is a new high-tech enterprise engaged in research, manufacturing and marketing of LED light. The main products involve which is a new high-tech enterprise engaged in research, manufacturing and marketing of LED light. The main products involve Flexible LED strip, LED spotlight, LED tube and LED accessories, etc. ,all of which are widely used for urban lighting decoration, indoor home decoration, hotel decoration, stage lighting, signal lamp, road lighting and other areas.
Related News
Energy consumption of Lighting Energy consumption of Lighting
Feb .28.2020
As LED lighting is more environmental friendly thus led strip manufacture pays a lot of attention in LED market.
Top 5 Things about LED Lighting Top 5 Things about LED Lighting
Aug .01.2019
LED stands for "light emitting diode" and it's those diodes that make the lights different from traditional incandescent and CFL bulbs, which contain filaments inside a glass bulb. The LED "bulb" contains tiny light sources or lenses that illuminate when